1. Always check whether the temperature of the reducer, coupling, motor and all the rollers are normal.

2. Always check the belt joints and find that the partial damage should be repaired or replaced in time.

3. If the conveyor belt is found to have slippage on the drive roller, it is necessary to find out the cause and adjust it in time.

4. The rotating parts of the belt conveyor must have good lining conveyor lubrication. The lubricating parts should be regularly filled with oil to change the oil according to the requirements of use.

5. The roller should be inspected regularly. During the inspection, an appropriate amount of grease must be added to the sealing ring. The roller that is not flexible should be replaced immediately.

6. When the conveyor is working, it is not allowed to repair or squat on the belt of the scraper conveyor.

7. When the fault is handled, the power supply should be cut off and the live working is strictly prohibited.

8, should ensure that the cleaner has a good working condition, such as component damage should be replaced in time.

9. Before each shift, it is necessary to check whether the hydraulic conveyor coupling has oil leakage, whether the fusible plug is qualified, and check the oil filling capacity of the chain-type conveyor hydraulic coupling, and find that the oil quantity is insufficient in time. supplement.

10. Always check the tension of the conveyor belt. If the slack phenomenon is found, the MS-type buried scraper conveyor should be tensioned in time. After tensioning, pay attention to whether the belt is deflected and adjusted in time.